How powerful is Pelche + water cooling? Try "Master Liquid ML360 SUB-ZERO"

Intel Cryo Cooling Technology with 3 modes of operation

The Pelche element mounted on the MasterLiquid ML360 SUB-ZERO is designed to operate under the control of Intel Cryo Cooling Technology. To demonstrate its cooling performance, connect the MasterLiquid ML360 SUB-ZERO to the motherboard via USB and then Intel. You need to use the utility of Cryo Cooling Technology. Conversely, if these are not prepared, the Pelche element will not function effectively.

You need to install the Intel Cryo Cooling Technology utility, which requires you to connect the Micro USB port on the water block to the USB 2.0 header on the motherboard with the included cable.Supported OS is Windows 10 64bit version only

Once set up, the Intel Cryo Cooling Technology utility resides in the task tray and controls the Pelche element based on the mode of operation selected by the user.

There are three modes available: "Standby" that turns off the Pelche element, "Cryo" that controls the Pelche element according to the load to avoid the occurrence of dew condensation, and "Unregulated" that makes the best use of the Pelche element. .. The recommended mode for normal use is Cryo, and Unregulated carries the risk of condensation. In addition, even with Standby, which does not use Pelche elements, sufficient cooling performance can be obtained to operate a CPU with rated operation.

When I actually tried each operation mode, the power of the Pelche element operated at about 150 to 166W in Unregulated, while the power changed in the range of 0 to 166W depending on the temperature in Cryo. As a result, in Unregulated, the cooler temperature was controlled to fall below the freezing point, whereas in Cryo, it was controlled so as not to fall below the dew point temperature (Dew Point). In Standby, the power of the Pelche element was always 0W regardless of the temperature.

Operating in Unregulated mode. Even if it is below the dew point temperature, the Pelche element is operating at 152W, and the cooler temperature is operating in Standby mode, which has dropped to -8.7 ° C.The power of the Pelche element is always off (= 0W) regardless of the temperature. When the cooler temperature operating in) reaches 20.3 ° C, the power of the Pelche element is 25W, and it can be seen that the output is adjusted so that it does not fall below the dew point temperature. "Mode" is prepared, and if you select Cryo mode after checking it, Cryo mode will be applied automatically from the next startup. If you do not use Remember Cryo Mode, Standby mode will be automatically selected when Windows starts. Ru